Owner`s manual

8
9
The DIP switch 1 to 8 definitions are as follows:
• Switch 1 - controls channels 1 and 2
• Switch 2 - controls channels 3 and 4
• Switch 3 - controls channels 5 and 6
• Switch 4 - controls channels 7 and 8
• Switch 5 - controls channels 9 and 10
• Switch 6 - controls channels 11 and 12
• Switch 7 - controls channels 13 and 14
• Switch 8 - controls channels 15 and 16
 

         
The example above shows a configuration where channel pairs 3-4,
13-14, and 15-16 are set for stereo operation.
Mode Select Switches
Positions 9 and 10 of the DIP switch are used for card mode selection.
There are four possible switch combinations; three operational modes
and one test mode are provided.
The Y1 card is scanned during the Yamaha console boot-up procedure
only. It is therefore important to remember that mode changes should
be made only while the console is off. If it is necessary to alter the Y1
card operational mode after the console has been booted, a console
restart will be required in order for the mode change to be recognized.
■ Switch 9 ON and Switch 10 OFF – Aviom Mode
 

         
The Yamaha console software recognizes the Aviom Y1
A-Net card ID’s and will display “Aviom” in all text fields
related to the expansion card.