Manual

16D800 anD D800-Dante a-net Distributors user GuiDe
Power Supply
The rear of the D800 A-Net Distributor contains the standard IEC power input for the unit. The main power
supply in the D800 is a switching type, compatible with the variety of electrical systems in use worldwide.
The D800 can operate with input voltages from 100 to 240 volts and at rates from 50 to 60 Hz. Replaceable
IEC cables for AC power systems throughout the world are available from many electronics dealers. Avoid
using cable adapters whenever possible. Replacement cables must provide an earth ground connection.
Fuse
The D800’s power supply fuse is contained in the round receptacle next to the power connector assembly.
To change a fuse, first unplug the unit from the AC wall receptacle. Remove the fuse access panel to reveal
the fuse. Always replace the fuse with one of the same rating—250VAC - T4AL.
Always replace the fuse with one of the same rating.
Ethernet Network Connection
The D800 can provide an enhanced personal mixing experience to users of the A360 Personal Mixer via
iOS. Each A360 connected to a D800 can display this optional mix information on a supported iOS device
such as an iPhone or iPad. A properly configured Wi-Fi router is required to use iOS support. This feature
will be enabled in a future firmware update.
P
Note: The front panel mode switch must be in the bidirectional (II) position for each A360 Personal
Mixer that will be using iOS support.
The iOS support feature is only available when using A360 Personal Mixers; the A-16II Personal Mixer
cannot take advantage of the advanced information display. Each D800 can support up to eight A360
Personal Mixers.