Installation guide

DMP-300 INSTALLATION GUIDE PAGE 18 OF 20
P/N DMP010 V3.0
6.2 Error Messages
In addition, the DMP-300 may display the following error messages:
Display Meaning Possible Causes
Invalid Card, no
firmware.
The firmware update file,
“0002.hex”, cannot be opened on
the CompactFlash card.
• The card was not prepared
using DMP-300 CardPrep
software
• The card was created for a
DMP100 or DMP200
Invalid Card, no MP3
config.
The MP3 configuration file,
“0002.xd3”, cannot be opened on
the CompactFlash card.
• The card was not prepared
using DMP-300 CardPrep
software
• The card was created for a
DMP100 or DMP 200
Internal error number XX
A fault has occurred between the
two internal processors of the
DMP-300.
Contact Avionics Innovations.
Please record the error number
shown on the display.
Memory Card Not
Inserted!
The DMP-300 is not detecting the
presence of a CompactFlash
card.
• No card is inserted
• The card is defective
• The card is not fully seated