Installation guide

DMP-100 INSTALLATION GUIDE PAGE 17 OF 20
P/N DMP010 V1.7
6.2 Error Messages
In addition, the DMP-100 may display the following error messages:
Display Meaning Possible Causes
Invalid Card, no
firmware.
The firmware update file,
“000.hex”, cannot be opened on
the CompactFlash card.
• The card was not prepared
using DMP100 CardPrep
software
• The card was created for a
DMP200
Invalid Card, no MP3
config.
The MP3 configuration file,
“000.xd3”, cannot be opened on
the CompactFlash card.
• The card was not prepared
using DMP100 CardPrep
software
• The card was created for a
DMP200
Internal error number
XX
A fault has occurred between
the two internal processors of
the DMP100.
Contact Avionics Innovations.
Please record the error number
shown on the display.
Memory Card Not
Inserted!
The DMP100 is not detecting
the presence of a
CompactFlash card.
• No card is inserted
• The card is defective
• The card is not fully seated