User Manual

3. Installation of main wing

• The main wing centre piece houses the motors, ESC’s, flaps, flap servos and main wiring harness.

• Please centre all servos, flex the ailerons on the outer wing panels.

• Connect all control rods to the cont rol horns with the supplied hardware to the flaps and Ailerons.

• Make the wiring harness is labelled and organised then bundled together to keep the wiring harness

from getting caught between the main centre wing and fuselage.

• Use the two M4 x 55mm main wing machine screws to secure the main centre wing section to the

fuselage.

• Use the two square machined aluminium wing spares and slide them into the main wing section,

attach the servo extensions to power your lights and ailerons.

• After you home the outer wing to the centre main wing section use the four 2mm x 15mm self-tap-

ping screws to fasten the outer wing sections to the main centre wing section.

• Attach the wing strut support with the 4 available split pins. Please check the wing at this point to

make sure the dihedral angle is even with both outer wing sections.