BushMule V2 Manual

19
TROUBLE SHOOTING:
Problem Cause Solution
Motors do not turn
Control surfaces
not moving with
stick input
Model doesn’t
fly straight
1. Control surfaces not centered.
2. CoG is not in the correct position.
Model does not
climb well
1. The battery is not fully charged.
2. Elevator servo is reversed.
3. CG too far backwards.
Limited Radio
range
1. Transmitter/Receiver batteries
are flat.
1. charge/replace batteries.
Model moves
backwards
1. Swap the props around.
1. Charge the batteries.
2. Install a full charged battery.
3. Check for connection between the
ESC and motor.
4. Replace motor.
5. Consult Radio manual and go
through bind procedure again.
6. Hold model and move throttle to full
postion then back down to idle.
1. Props installed incorrectly
1. The servo lead is connected to \
Rx incorrectly.
2. The servo is damaged.
1. Make sure the servo leads are
connect properly.
2. Replace servo.
1. Adjust the trims on the transmitter.
2. Re-possition lipo as suggested.
1. Charge the battery.
2. Change servo direction via Tx.
3. Move battery forwards.
For more information on this model and the entire range from Avios please visit us at:
• hobbyking.com
Or see our Facebook page at:
• Facebook.com/hobbyking
And don’t forget you can see the product video for this model and the entire Avios range at:
• youtube.com/hobbykinglive
For your next Avios purchase be sure to visit:
• hobbyking.com
Battery is not fully charged.
Transmitter battery low.
Motors not connected.
The motor is damaged.
Rec ver is not bound to Tx.
ESC in set-up mode.
CONTACT: