W I TH O R X S T ABIL IZ E R INSTRUCTION MANUAL
This plane is guaranteed to be free from defects in material and workmanship at the date of purchase. It does not cover any damage caused by use or modification. The warranty does not extend beyond the product itself and is limited only to the original cost. By the act of controlling this product, the user accepts all resulting liability for damage caused by the final product. If the buyer is not prepared to accept this liability, it can be returned new and unused to the place of purchase for a refund.
SAFETY INSTRUCTIONS 1. Please read this manual carefully and follow the instructions before you use this product. 2. This airplane is not a toy but due to having installed the ORX stabilization system it is suitable for pilots with low experience. However, if you do fall into this category then we recommend you enlist the help of an experienced RIC pilot to give you a hand with the initial flights. 3. Not recommended for children under 14 years old. 4.
Kit content PNF Version Fuselage, Main Wing, Horizontal Stabilizer, Main Landing Gear, Propeller, Missile set, Drop tanks and an accessory bag.
Assembly Instruction: 1. Assembly of the main landing gear Install the landing gear into the slots which are located on the underside of the main wing. Note: Both wheels face each other. Secure each one using 2 x 8mm self-tapping screws. 2. Assembly of the main wing Connect the aileron servo connectors together. Then install the main wing onto the fuselage wing saddle using the supplied 4 x 35mm machine screw to secure it in place. 3.
4. Attaching the fin and rudder assembly to the fuselage. Before you insert the fin post into the slot in the rear of the fuselage, ensure the tail wheel is aligned as shown in the picture below. Apply some glue to the base of the fin and the mounting tab and insert it into the slot. At the same time, the U-shaped wire also needs to be aligned straight before you insert and glue the fin/rudder assembly into place. Ensure the fin/rudder assembly remains at 90° to the wing and stabilizer as the glue sets. 5.
. Attaching the drop tank to the main wing Apply glue to the drop tank and glue it into the indent which is located beneath the wing as shown. 8. Your F4U Corsair is complete Check the center of gravity and make sure it is within the range shown below. For initial flights it is best to balance the model on or near the 40mm mark to make the flying characteristics more docile.
ORX flight stabilisation system Features: • Integrated with a 32bit MCU and a 6 axis digital gyro for ultra fast flight control response • The ORX stabilization device is tuned specifically to a particular model for the best flying performance. • Supports PWM, PPM and SBUS. Auto-detect. • Supports 2 different flight modes (Beginner and Expert) Channel Input: • PWM input: Here is the channel assignment and shown as follows. Ch 1. Aileron, Ch 2.
Flying the VOUGHT F4U CORSAIR Re-check the center of gravity, move the battery position if necessary so that it balances in a very slight nose down attitude somewhere near the forward mark (40mm). Check that the linkages and push-rods are secure, the propeller is secure and the wings are correctly attached. Switch on the transmitter with the throttle closed and the throttle trim fully down then connect the flight battery.
Accessories Turnigy nano-tech 850mah 3S 25~40C Lipo Pack Turnigy 800mAh 3S 20C Lipo Pack SKU: N850.3S.25 SKU: T800.3S.
Made in China