User manual

- 23-
Ref#92550806002
6.) When action delay has been reached the Action will be set off. Here we
have set the 9258xx to Reset the device.
7.) Once the device has been reset the 9258xx will go into Startup Delay
mode. In this case it is 3 seconds.
8.) After the startup delay mode has been reached the 9258xx will check the
Startup Action whether to continue or stop pinging the device. Here we
have it set to Continue.
9.) Then the process starts all over.
10.) Since the Ping Type is set to or if any of the Ping IP constitute a failure then
the action will be committed. If the Ping Type was set to "AND" all
conditions must be met for the action to be activated.
Setup
The setup page allows the user to configure the system settings of the 9258xx.
This includes network information, IP Server, CNT, CGI commands, and the
firmware version.