User manual

You can change the properties of the scan engine under Basic Configuration - Utility

Settings - AntiVir Engine - Properties.

•

The name of the Avira antivirus interface DLL must be entered in the Avira AV

Interface field. This DLL file represents the link between Avira AntiVir Exchange

and the virus scanner. This entry is pre-configured for all scan engines and must not

be changed! In the Parameter field, enter the parameter to be used by the virus

scanner for scanning.

•

To configure the virus scanner so that e-mails or attachments are cleaned when a

virus is detected, enable the Different clean parameter option and enter the

appropriate parameter in the Clean parameter field underneath.

Note: If you wish to use the scan engine for virus checking only, use the AntiVir job

Scanning with AntiVir Engine and disable the Remove malware option in the

Actions tab. If the virus scanner is to clean any infected files found, use the AntiVir

job Scanning and disinfection with AntiVir Engine. In this case, the option

Remove malware needs to be enabled and the actions to be performed for infected

mails must have been set.

Avira AntiVir Exchange 7