User Guide
Table Of Contents
- 1. Installing the Button Manager
- 2. Scanning From the Button
- 2.1. Checking the Button Configurations Before Scanning
- 2.2. The Default Button Settings
- 2.3. Scanning From A Simple Touch of the Button
- 2.4 Performing Continuous Scan From the Flatbed
- 3. Configuring the Buttons
- 3.1. A Glance of the Button Properties Window
- 3.2. Choosing New Settings For A Button
- 3.3. Choosing a Proper File Format
- 3.4 Adding A New Destination Application
- 3.5 Deleting A Current Destination Application
- 3.6 Creating A New Scan Configuration
- 3.7 Deleting A Current Scan Configuration
- 3.8 Selecting Options For a Button
- 3.9 Removing a Blank Page
- 3.10 Setting the Power Saving Mode
- 3.11 Saving and Loading Profiles
- 3.12 Solving A Problem
- Index
29
Additional Length Detection
Additional Length Detection allows you to define the length of
document being multi-fed. This value indicates the additional
length exceeding your designated scan area. The Display
window will show the size of the document as you change the
value. A value of 0 indicates no additional length detection.
The Additional Length Detection is best used when scanning
same-size documents in the auto document feeder.
There are two options available if Multi-Feed is detected.
z Stop Scanning after Multi-Feed
If this is selected, the scanner will stop the feeder if
multi-feed is detected.
z Multi-Feed Alarm:
If this is selected and a wave file is added, the scanner
will produce a sound alarm if multi-feed is detected.