User Guide

Setting up Your Machine
2-4
Setting up the Optional ADF (Auto Document Feeder)
1. As shown in the figure below, lift the document cover to remove the
studs from the hinge holes. The studs are loosely attached to the
hinge holes in the purpose to cover your original when it is a few
inches high.
2. Insert the studs of the ADF cover to the hinge holes on the document
glass.
3. Raise the ADF Tray to about 45 degrees.
4. Pull down the wire legs beneath the ADF Tray and insert the wire legs
to the holes on the document cover.
5. Pull out the ADF Tray extension to its full length.
ADF Wire Legs
ADF Tray
Extension
Stud
Document
Cover
Hinge hole