User's Manual

Tips for Measuring Human Temperature
Bear in mind that the thermometer needs to have been in the
room in which the measurement is taken for at least 30
minutes before use.
NOTE:
• Attempting to take temperature readings from sites on the
body other than the forehead may produce inaccurate
results.
• The patient should remain still while the reading is being
taken.
• Infrared forehead temperature readings are equivalent to
oral temperature readings. In all of these cases, please
consult your doctor.
• Readings taken while asleep should not be compared
directly to readings taken while awake, as body
temperature while asleep is typically lower.
• Do not take body temperature readings within 30 minutes
of being outdoors, exercising or bathing.
Measuring Human Temperature
Taking a Measurement
1. Press the Measure button to power on the thermometer.
The unit will run a self-test and the LCD will briefly display
all of its symbols during this time. When the device is ready,
‘00’ will appear on the screen, and the thermometer will
beep twice.
2. Select the desired mode by pressing and releasing the
Human/Object button.
Note:
- When taking a patient’s temperature, ensure that the
thermometer is in Human mode; the Human symbol
“ ”will appear on the display.
- If the patient’s skin is covered with hair, sweat, or dirt, clean
the area and wait 10 minutes before taking a measurement.
- Ensure that the thermometer is held firmly during
measurement and that the patient does not move until the
measurement is complete. Movement can impact the
measurement.
7
Measuring Human Temperature
3. Position the thermometer under 3cm (around 1 inches)
from the center of the patient's forehead with the sensor
aimed between the eyebrows.
4. Press and release the Measure button.
5. Slowly move the device toward or farther from the
forehead until you have reached the correct distance. (If
the distance is beyond the correct distance, the dash-icon
on the display flashes with beep sound in this sequence
until the correct distance is achieved. )
Note:
When the user presses the measure button,
this workflow begins and they have 20
seconds to capture the temperature. After 20
seconds, the display turn to stand-by mode.
6. As you hear a short beep means this
temperature reading has been completed
and accompany with a back-light.
7. If the temperature measurement is below
38°C, a “Smiling Face ” will be appear
next to the reading. If the reading is 38°C
or above, a “Frowning Face ” will be
displayed and the RED LED light up.
8. After about 30 seconds after use, the
thermometer will automatically beep and
shut off.
Fever Alarm:
Only in Human Mode and Human/Night Mode
8