AviStart 3000 Owner's Manual
I WARNING I ! Always exercise caution and common sense when operating your AviStart system. ! This product is intended for vehicles with fuel-injection and automatic transmissions only. NEVER attempt to remote start a vehicle with a manual (stick shift) transmission. Serious injury may occur with improper use. ! NEVER attempt to remote start the engine while anyone (including pets) is in the vehicle.
Table of Contents AviStart 3000 . . . . . . . . . . . . . . . . . . . . . Lifetime Warranty . . . . . . . . . . . . . . . . . . Remote Controls . . . . . . . . . . . . . . . . . . Stealth Coding Technology. . . . . . . . . . . . . Electronic Scan Prevention (ESP). . . . . . . . . . . Instant Remote Control Code Deletion. . . . . . . . One-Step Remote Control Code Learning . . . . . . Valet Switch . . . . . . . . . . . . . . . . . . . . . Operating Your AviStart . . . . . . . . . . . . . . . .
AviStart 3000 Congratulations! You have just purchased the AviStart 3000, a remote engine starter system manufactured by Avital Technologies, Inc. You are about to experience the convenience and luxury of being able to start your vehicle engine from the comfort of your home, office, department store or other remote location. To fully benefit from the capabilities of your AviStart system, we encourage you to read the Owner’s Manual thoroughly before using the system.
Stealth Coding Technology Stealth Coding technology offers the most advanced protection available against "code-grabbing" devices which thieves may use to record the digital code transmitted by your remote control. When you leave the area, thieves can then play back the code to start or stop your system. Avital's remote controls with Stealth Coding randomly change the code every time you use them, and your system will not respond if any code is retransmitted.
Operating Your AviStart Remote Engine Start - Safety and Counter-Theft Be sure to read the "WARNING" bulletin on the inside cover of this manual before attempting to operate remote start. I CAUTION: Automatic Safety and Counter-Theft Features Before remote starting your engine, the AviStart system will automatically perform a safety check to ensure the following conditions have been met: • Brake pedal is not depressed. • Engine and ignition are turned "OFF." • Hood is closed.
To Unlock the Doors Press the remote control LOCK/UNLOCK button for 1-2 seconds. The doors will unlock and the parking lights will flash once. Remote Engine Start - Operation Your AviStart system will start your vehicle engine with a touch of a button on your remote control. Before remote starting, ensure the vehicle is in "Park" and the key is not in the ignition. To cool or warm the interior of your vehicle, preset the climate control to your preference (heater, defrost or air conditioning).
User-Programmable Temperature-Controlled Starting Do not activate Temperature-Controlled Starting while the vehicle is in an enclosed area. I CAUTION: The AviStart system can be programmed to monitor the air temperature inside your vehicle and automatically start the vehicle engine whenever the temperature inside reaches or drops below a preprogrammed temperature level. There are three temperature levels to choose from. (This feature is programmed OFF from the factory and must be programmed ON to operate.
To Activate 1. While the vehicle engine is running with the ignition key turned "ON," press the remote control START button for 1-2 seconds. The parking lights will flash 2 times and stay on. (Make sure the vehicle is in "Park" and the parking brake is set.) 2. Turn the ignition key "OFF" and the engine will stay running. 3. Remove the ignition key and remote control and exit the vehicle. Remember to keep the ignition key and remote control in your possession. 4.
User-Programmable Features All AviStart system and remote control programmable features are accomplished by turning the ignition key "ON" (or starting the engine) and flicking the valet switch on and off a preset number of times. The AviStart also allows you to add new remote controls in one step, delete lost or stolen remote controls or rearrange the factory preset remote control functions. 1. Remove the system from Protected Valet Mode.
Programming Table for System Features Feature Factory Setting No. of beeps Secondary Action OFF 5 Wait 3 seconds. The piezo beeper will beep once for OFF, twice for 5°F (-15°C). — 7 Wait 3 seconds. The piezo beeper will beep once for -7°F (-20°C), twice for -22°F (-30°C). Temperature-Controlled Starting OFF or 5°F (-15°C) Temperature-Controlled Starting -7°F (-20°C) or -22°F (-30°C) Programming Table for Remote Controls Feature Factory Setting No.
© Copyright Avital Technologies, Inc.