Installation manual

Important Information

Recommended Installation Tools

Voltmeter

Wire Strippers

Electrical Drill & Bits

Phillips Screwdriver

Convoluted Tubing *

Solder Gun *

Wire Crimpers

Shrink Tube or Electrical Tape

* Optional

Recommended Procedures

1. Test all circuits with a voltmeter.

2. Make all wiring connections with the supplied solderless crimp

connectors. DO NOT twist wires or use scotch-lok connectors.

3. Route the small and large RED, RED/WHITE and BLACK wires from the

control unit directly to the battery.

4. Keep extensions as short as possible. Use same gauge wires for short

extensions and larger gauge wires for longer extensions.

5.. DO NOT disconnect the battery cables. Make all connections by

removing the bolts from the cable clamps without detaching the clamp.

6. Turn off dome light or remove dome light fuse to prevent battery drain.

This device complies with Part 15 of the FCC rules. Any changes or modifications

made to the system without the express approval of Avital Technologies, Inc.

could void the user’s authority to operate this equipment.

AviStart 3001 Installation Manual, Revision B 100199