Avital 3001L Owner s Guide
© 2009 Directed Electronics
Limited consumer warranty For a period of one calendar year from the date of purchase of this auto-security device, Directed Electronics, (Directed) promises to the ORIGINAL PURCHASER to repair or replace (at Directed’s election) with a comparable reconditioned model, any Directed unit (hereafter the “unit”), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories which proves to be defective in workmanship or material under reasonable use, provided the follow
LAW, ALL WARRANTIES ARE EXCLUDED, INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY AND/OR ANY AND ALL WARRANTY OF FITNESSFOR A PARTICULAR PURPOSE AND/OR ANY AND ALL WARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THE UNITED STATES OF AMERICA AND/OR ABROAD. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER’S PURCHASE PRICE OF THE UNIT.
Contents Limited consumer warranty . . . . .i Nuisance prevention circuitry® . .8 Trademarks and copyrights . . . . .1 Diagnostics . . . . . . . . . . . . . . . . . .9 What is included . . . . . . . . . . . . .2 Arming diagnostics .........9 Important information . . . . . . . . .2 Using your system . . . . . . . . . . . .3 Manual (active) arming ......3 Automatic (passive) arming ..3 Disarming diagnostics ......9 Table of zones ...........10 Rapid resume logic . . . . . . . . . . .
What is included Control module and harness A Stingerfi dual stage shock sensor (on-board the control module) Pre-wired Valet switch Status LED Failsafefi Starter Kill relay (if equipped) Important information Congratulations on the purchase of your security system. Due to the complexity of this system, it must be installed by an authorized dealer only. Installation of this product by anyone other than an authorized dealer voids the warranty.
Using your system Manual (active) arming The factory default is active arming. You can activate or arm the system by locking the doors with your factory keyless entry transmitter. When the system arms, you will hear a short siren chirp and see the parking lights flash once. Note: The system can be programmed to sound horn honks or siren chirps. The horn is optional and may require additional labor.
If any protected entry point (such as a door or a switch-protected trunk or hood) is open, the system will not passively arm. Additionally, each time a sensor is triggered during the arming countdown, the 30-second countdown starts over. Note: Passive arming may qualify for a higher insurance discount. Check with your insurance agent Armed protection When armed, your vehicle is protected as follows: Light impacts to your vehicle trigger the warn away signal.
Disarming To disarm the system, unlock the doors using your factory keyless transmitter. The siren sounds twice, and the parking lights flash twice. If the siren sounds either four or five times when disarming, refer to the Diagnostics section of this guide. This is called Tamper Alert. Disarming without a transmitter This feature allows you to override the system without the transmitter should it be lost, damaged or disabled.
Valet mode You can prevent your system from arming, by using Valet Mode. This is very useful when washing the vehicle or having it serviced. In Valet Mode the system will not arm, but all convenience functions (door locks, trunk release, etc.) will work normally. To enter or exit Valet® Mode with the Valet switch: Turn ignition to on position, then turn to off position. Press and release the Valet DRW-35 switch within 10 seconds. The status LED will light steady if you have entered Valet Mode.
Panic mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transmitter! If your factory keyless transmitter does not have a panic button, this system can be programmed by your installer to enable a panic feature (refer to the Programming Options). If enabled, just press the lock button on your factory keyless transmitter twice within three seconds to enter Panic Mode. The siren sounds and the parking lights flash for 30 seconds.
Nuisance prevention circuitryfi Your system has Nuisance Prevention Circuitry (NPC). This circuitry prevents annoying repetitive trigger sequences due to faulty door pin switches or environmental conditions such as thunder, jackhammers, airport noise, etc. Here’s how it works: The alarm triggers three times. Each time, the same sensor or switch is triggering the alarm. The three triggers are within 60 minutes of each other.Your system will interpret this pattern of triggers as false alarms.
Diagnostics The microprocessor at the heart of your system is constantly monitoring the switches and sensors connected to it. It detects any faulty switches and sensors and prevents them from disabling the entire system. The microprocessor also records and reports any triggers that occurred during your absence. Arming diagnostics If the system is armed with an input active (door open, sensor triggering, etc.) the unit will chirp once when arming and then one more time a few seconds later.
Table of zones The number of LED flashes the system uses to identify inputs is represented by a Zone. The standard Input assignments for zones are described below. Zone/LED Flashes Input description 1 Instant trigger - often used for hood/trunk pin switches 2 Instant trigger - a heavier impact detected by the shock sensor 3 Door switch trigger 4 Optional sensor 5 Ignition trigger The LED will not report if the Warn Away response is triggered.
Programming options Programming options control your system’s normal, operational setup. Most options do not require additional parts, but some may require additional labor.All programming options must be set by your installer. Programming settings The following is a list of the program settings that can be set by your installer. Note: Factory default setting is shown in bold. 1. Active or passive arming (automatic arming 30-seconds after closing the last door). 2.
7. Door Trigger delayed or instant: In the delayed configuration the unit will provide a progressive response if the door is opened while the system is armed. The system will chirp and the parking lights will flash for a few seconds followed by a full trigger response when the door is opened. In the instant mode, the system will trigger the full trigger response. 8. Sensor shunt zones 2 and 4 or All zones. 9. Siren duration - 30 seconds or 60 seconds. 10.
Glossary of terms Control Module: The brain of your system. Usually hidden underneath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all of the alarm s functions. Failsafe® Starter Kill (if equipped): An automatic switch controlled by the security system which prevents the vehicle s starter from cranking whenever the system is armed.
14
Notes © 2009 Directed Electronics 15
Notes 16 © 2009 Directed Electronics
Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet. ✂ QUICK REFERENCE GUIDE To arm the system ■ You can arm the system by locking the doors with your factory keyless entry transmitter. When the system arms, you will hear a short siren chirp, and see the parking lights flash once. To disarm the system ■ To disarm the system, unlock the doors using your factory keyless transmitter. You will hear two siren chirps, and the parking lights will flash twice.
✂ Table of Zones Input description 1 Instant trigger - often used for hood/trunk pin switches 2 Instant trigger - a heavier impact detected by the shock sensor 3 Door switch trigger 4 Optional sensor 5 Ignition trigger Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet. Zone/LED Flashes ✂ The LED will not report if the Warn Away response is triggered.
19
The company behind this system is Directed Electronics. Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology, DIRECTED is ISO 9001 registered. Quality Directed Electronics products are sold and serviced throughout North America and around the world.
