User manual

Table of zones

The number of LED flashes the system uses to identify input s is rep -

resented by a Zone. The st andard Input assignment s for zones are

described below.

Zone/LED Flashes Input description

Instant trigger - often used

for hood/trunk pin switches

2 Instant trigger - a heavier impact

detected by the shock sensor

3 Door switch trigger

4 Optional sensor

5 Ignition trigger

The LED will not report if the W arn A way response is triggered.

Rapid resume logic

This system will store it s current st ate to non-volatile memory. If

power is lost and then reconnected the system will recall the stored

state from memory. This means if the unit is in V alet Mode and the

battery is disconnected for any reason, such as servicing the car ,

when the battery is reconnected the unit will still be in V alet Mode.

This applies to all st ates of the system including arm, disarm, and

V alet Mode.