I WARNING I ! Always exercise caution and common sense when operating your AviStart system. ! This product is intended for vehicles with fuel-injection and automatic transmissions only. NEVER attempt to remote start a vehicle with a manual (stick shift) transmission. Serious injury may occur with improper use. ! NEVER attempt to remote start the engine while anyone (including pets) is in the vehicle.
Table of Contents AviStart 6501 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Lifetime Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Remote Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Stealth Coding Technology. . . . . . . . . . . . . . . . . . . . . . . 3 Electronic Scan Prevention (ESP). . . . . . . . . . . . . . . . . . . . . 3 Instant Remote Control Code Deletion. . . . . . . . . . . . . . . . . . 3 One-Step Remote Control Code Learning . .
AviStart 6501 Congratulations! You have just purchased the AviStart 6501, a remote engine starter and security system manufactured by Avital Technologies, Inc. You are about to experience the convenience and luxury of being able to start your vehicle engine from the comfort of your home, office, department store or other remote location. To fully benefit from the capabilities of your AviStart system, we encourage you to read the Owner’s Manual thoroughly before using the system.
Stealth Coding Technology Stealth Coding technology offers the most advanced protection available against "code-grabbing" devices which thieves may use to record the digital code transmitted by your remote control. When you leave the area, thieves can then play back the code to unlock the doors and deactivate your system. Avital's remote controls with Stealth Coding randomly change the code every time you use them, and your system will not respond if any code is retransmitted.
Operating Your AviStart To Arm The System The alarm can be programmed for active or passive arming. Active arming means the alarm can only be armed by the remote control. Passive arming means the alarm will automatically arm itself. See the "Programming Table for System Features" on page 15. Active Arming Press the A button on your remote control for 1-2 seconds. The siren will chirp twice, the parking lights will flash twice, the doors will lock, the LED will flash slowly and the starter will be disabled.
Two-Stage Unlock Capability If the optional Two-Stage Unlock feature was installed, press the A or H button for 1-2 seconds and only the driver door will unlock. Within 3 seconds, press the A or H button again and the passenger doors will unlock (may require an optional relay). Remote Panic with Safety Locks In a threatening situation, you can activate Remote Panic with Safety Locks. When activated, the siren will sound and the parking lights will flash.
User-Programmable RPM Door Lock The system can be programmed to automatically lock the doors when the engine reaches the factory preset RPM level. (See the "Programming Table for System Features" on page 15). When you begin driving, your vehicle doors will automatically lock. When you turn the ignition key off, the doors will automatically unlock. NOTE: Ignition-Controlled Door Lock feature must be programmed OFF.
To Activate Remote-Controlled Valet 1 . Press the A and s buttons at the same time for 1-2 seconds. 2 . The parking lights will flash 4 times, and the LED will turn on solid red. To Deactivate Remote-Controlled Valet 1 . Press the A and s buttons at the same time for 1-2 seconds. 2 . The parking lights will flash 3 times and the LED will turn off. LED System Status Indicator The LED on your vehicle dashboard or center console will inform you of the system status.
Zone #2: If a more threatening vibration or impact is detected at any time, the siren and lights will activate instantly. Remote-Controlled Sensor Bypass You can bypass the system sensor(s) at any time. The alarm system will still provide full perimeter protection. To 1. 2. 3. Bypass the Sensor(s): Press remote H and dbuttons at the same time. The siren will chirp twice...pause...chirp twice...pause...chirp twice. The sensor(s) is now bypassed until you remotely disarm and then rearm your system.
User-Programmable Siren Duration Upon activation, the siren can be programmed to run for 30 or 60 seconds before it will shut off and instantly rearm. ( See the "Programming Table for System Features" on page 15.) Alarm State Memory If your vehicle battery is disconnected and later reconnected, the system will automatically return to its last state before power was removed, whether it was armed, disarmed or in a valet mode.
Number of chirps and flashes Explanation 2 three-second flashes or 1 three-second flash Remote automatic temperature-controlled starting. 2 = activation, 1 = deactivation. 0 chirps, 4 light flashes Remote valet activation. 0 chirps, 3 light flashes Remote valet deactivation. 6 chirps, 0 light flashes Remote sensor bypass. 2 chirps and flashes, then 3 more chirps and flashes Armed and a door is open or ajar. 0 chirps, 4 light flashes Remote start attempt and system is in Protected Valet Mode.
Remote Engine Start - Operation Your AviStart system will start your vehicle engine with a touch of a button on your AviGlo™ remote control. To cool or warm the interior of your vehicle before you enter, set the climate control to your preference (heater, defrost or air conditioning) before remote starting. Set the fan to a medium speed (not maximum). Ensure the vehicle is in "Park" and the key is not in the ignition.
To Shut Off Remote Start: At any time while the engine is remote started, you can shut off the engine with the remote control by pressing the remote control s button for 1-2 seconds. The engine and parking lights will shut off. User-Programmable Temperature-Controlled Starting Do not activate Temperature-Controlled Starting while the vehicle is in an enclosed area.
Pit Stop Mode : Do not leave passengers or pets in the vehicle while the system is in Pit Stop Mode. I CAUTION The Pit Stop Mode allows you to park the vehicle for short-term stops, remove the ignition key and leave the engine running. To Activate: 1 . While the vehicle engine is running with the ignition key turned "ON," press the remote control s button for 1-2 seconds. The parking lights will flash 2 times and then stay on and the doors will unlock.
User-Programmable Features All AviStart system and remote control programmable features are accomplished by turning the ignition key "ON" (or starting the engine) and flicking the valet switch on and off a preset number of times. The AviStart also allows you to add new remote controls in one step, delete lost or stolen remote controls or rearrange the factory preset remote control functions. 1 . Remove the system from Protected Valet Mode.
Programming Table for System Features Feature Factory Setting No.
Programming Table for Remote Controls Feature Factory Setting No. of Chirps Secondary Action Arm/Disarm A Button 24 Press A Button, the siren will chirp 1 time. Remote-Controlled Trunk Release dButton 25 Press dButton, the siren will chirp 2 times. Remote Start s Button 26 Press s Button, the siren will chirp 3 times. Silent Arm/Disarm H Button 27 Press H Button, the siren will chirp 4 times. Remote-Controlled Valet A +s Buttons 28 Press A + s Buttons, the siren will chirp 5 times.
Life time Lim ited Fac tory War ranty - Terms and Con di tions Avital ve hi cle se cu rity sys tems and ac ces so ries re quire pro fes sional in stal la tion by an Authorized Avital Dealer. Un less the sys tem is sold and in stalled by an Authorized Avital Dealer, all prod uct warranties are void.
ONLINE REGISTRATION: For your convenience, we now provide online registration for your Avital purchase. Within 10 days of purchase, register at www.clifford.com/register. By registering online, you will have access to a copy of your Owner's Manual, as well as information on product updates or special promotions. Your sys tem se rial number is: Place se rial number sticker here © 1999 Avital Technologies, Inc.