Installation manual

Channel 6 Accessory (-) Output (Arm/Disarm + Option Buttons)
The LIGHT BLUE/YELLOW wire provides a 0.75 second (-) output when
activated whether the alarm is armed or disarmed. If the remote control
button(s) is continually pressed, the signal will stay at ground as long as the
button is held.
Parking Lights
1.
If the parking lights are positive trigger, connect the RED/WHITE wire to
the battery positive (+) terminal through the 20 amp fuse.
NOTE: Do not connect the RED/WHITE wire to the control unit
RED wire.
2.
If the parking lights are negative (-) trigger, connect the RED/WHITE wire
to control unit BLACK wire.
3.
Connect the RED/BLACK wire to the vehicle parking light wire.
Interior Light Trigger/Illumination
The system door trigger will accept a positive or negative door trigger input.
When the alarm is remotely disarmed, the interior lights will turn on for 30
seconds or until the ignition key is turned "ON." The WHITE/BLACK interior
light supply wire serves two purposes. It informs the alarm whether the door
trigger polarity is positive or negative switching and provides a positive or
negative supply for interior light illumination.
1.
Connect the WHITE wire to the vehicle door trigger wire(s).
2.
If the door trigger is negative switching, connect the WHITE/BLACK wire
to ground.
3.
If the door trigger wire is positive switching, connect the WHITE/BLACK
wire to a constant fused +12 volt source.
Starter Disable
The alarm can be installed as Normally Open (N.O.) or Normally Closed
(N.C.) starter disable. It is factory set for Normally Closed.
NOTE: Make sure the YELLOW relay wires are solidly connected. The starter
circuit may draw very high current. We recommend that all starter wire
connections be soldered.
7
Phoenix2 Rev. A - Installation Manual 0399