Phau Ntawv Qhia

Model 1278K Mobile VSAT Antenna System 9 Operation and Maintenance Manual
* Changing the DATA satellite *:
1. From the READY screen, press “ ÷” twice to move to the “DATA satellite” screen.
2. The blinking cursor will be over “SatA/SatB”.
2.1 Press “+” to change the DATA satellite from A to B.
3. Press “ENTER” to move the blinking cursor to “Satellite A”.
3.1 Press “+” or “-“ to change the longitude value for DATA satellite A.
3.2 Press “ENTER” to save the value.
4. Press “ENTER” to move the blinking cursor to “Satellite B.
4.1 Press “+” or “-“ to change the longitude value for DATA satellite B.
4.2 Press “ENTER” to save the value.
* Manual GPS Entry (This can be used if the automatic GPS system fails):
1. From the READY screen, press “MAIN” four times to reach the GPS screen.
2. The blinking cursor will be over NORMAL.
3. Press “+” to change to MAN.
4. Press “ENTER” to save the value.
5. Press “+” until the desired latitude is displayed.
6. Press “ENTER” to save the value and move to the LONG item.
7. Press “+” until the desired longitude is displayed.
8. Press “ENTER” to save the value.
* Manual Compass Entry (This can be used if the automatic compass system fails):
1. From the READY screen, press “MAIN” five times to reach the “COMPASS” screen.
2. The blinking cursor will be over “NORMAL”.
3. Press “+” to change to MAN.
4. Press “ENTER” to save the value.
5. Either jog the AZ or physically move the entire antenna to point approximately south.
6. Press “”MAIN”” to return to the READY screen.
Complete operating instructions will be found in the TES75 and TES960 controller manual.
Downloaded from www.Manualslib.com manuals search engine