User`s guide

CHAPTER 5
-
PROCALL-X COMMANDS
5.1 GENERAL
This chapter details all the commands
that are valid under PROCALL-X. A
shorter version of these
same commands
is contained in Appendix A.
5.2 PROGRAMMING COMMANDS
The subparagrahs that follow describe
the commands that are entered in the
columns labeled code and screen.
-
I 5.2.1 COMMANDS ENTERED UNDER THE CODE
HEADING
CT (CUT)
This cue turns the lamp ON or OFF
quickly. If the lamp is already ON,
this will turn the lamp OFF and initiate
a tray advance. If the lamp is off it
will then be turned ON. If you wish to
cross from one visual to another
quickly, a CUT will turn the
ON lamp OFF
and the OFF lamp
ON, and the projector
with the down going lamp will perform a
tray advance. A CUT employs the after
burner effect as described in the note
below.
7