User Manual

ManualsBrandsAvlex ManualsAudio accessoriesAD-707a Wideband 4-Channel Antenna Divider

AD-707a

User Guide

AS110601

MIPRO Electronics Co., Ltd.

Headquarters: 814 Pei-Kang Road, Chiayi, 60096, Taiwan.

Web: www.mipro.com.tw

E-mail: mipro@mipro.com.tw

Design and specifications are subject to change without prior notice

2CE378A

UHF Wideband 4-Channel Antenna Divider

Summary of content (5 pages)

PAGE 1
User Guide AD-707a UHF Wideband 4-Channel Antenna Divider MIPRO Electronics Co., Ltd. Headquarters: 814 Pei-Kang Road, Chiayi, 60096, Taiwan. Web: www.mipro.com.tw E-mail: mipro@mipro.com.
PAGE 2
WARNING ! IMPORTANT SAFETY INSTRUCTIONS ! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
PAGE 3
Antenna Divider System Antenna Divider System Contents Key Features and Benefits 1 Key Features and Benefits 1. Optimized for 470~800MHz carrier frequency range, which is fully compatible with US and EU telecom regulations. 2 Part Names and Functions 2. 3 Installation (2 Applications) Provided for 2~4 sets of UHF diversity receivers to operate from just a pair of antennas, greatly simplifying antenna installations and increasing reception distance and efficiency. 3.
PAGE 4
Antenna Divider System Antenna Divider System Part Names and Functions Installation (2 Applications) Front Panel: First Application: A ANT B BOOSTER AD-707a 0 B ANTENNA DIVIDER ANT A POWER (1) 1 2 3 (Figure 1) 1 Power On/Off Switch: When power is on, the light illuminates. 2 Booster Power Indicator: The light illuminates when remote antenna booster is connected and successfully powered from antenna-in connector 4 .
PAGE 5
Antenna Divider System Antenna Divider System Cautions Second Application: 1. Antenna-in connector 4 has 8.3V DC output. Be cautious that any parts of antenna or core wire of antenna cable should not make direct contact with case to avoid electric shortage. 2. It will not function properly if DC voltage falls below 12V. However, if it exceeds 15V, it will damage internal circuit components. 3. Use 50Ω coaxial cables between receiver and divider. Best to keep cable length as short as possible.