MI-808R Stereo Receiver User Guide Electronics Co., Ltd. Head office: 814, Pei-Kang Road, Chiayi, 600, Taiwan. Taipei office: 5, Lane 118, Sung-tehRoad, 100, Taipei, Taiwan. Web-http: //www.mipro.com.tw E-mail: mipro@mipro.com.
Index Stereo Receiver 1. Preface : 1. Preface: 2. Features of the MI-808R: 1 Thank you for choosing MIPRO's MI-808R miniature stereo receiver. 2 This system is engineered to meet the stringent requirements demanded in a variety of pro audio applications, such as by musicians, performers and directors. To get the most out of your system, please read this manual thoroughly. 3. Glossary : 3 4. Operating the MI-808R: 4-8 5.
Stereo Receiver 2. Features of MI-808R: Stereo Receiver 1 2 3 4 3. Glossary : The MI-808R is a UHF-band stereo bodypack receiver. In each 24 MHz bandwidth there are 16 pre-programmed, user selectable non-interfering frequencies available. The MI-808R employs advanced dual-antenna diversity reception to eliminate signal dropouts and to enhance signal stability.
Stereo Receiver Stereo Receiver 4. Operating the MI-808R: 3.Connecting Earphones (See Illustration Below) 1. Using Batteries And The Automatic Power Management System: Connect the stereo jack of the monitoring earphone to the 3.5mmf stereo connector. You can also use any conventional matching earphone or connect the output of receiver to the input of any audio device. The MI-808R miniature receiver can use either 2 conventional or rechargeable AA batteries.
Stereo Receiver Stereo Receiver 5. Setting Up The Receiver Channel (See Illustration Below) 7. Output Limit Switch For Earphone After holding the channel adjustor (8)for 2 seconds, the numeric LED panel ( 7 )will start flashing and the adjustor can be released. Then, pushing the adjustor once will increase the channel number. When the system reaches channel 16, it will cycle back to channel 1 and start the channel selection sequence again.
Stereo Receiver NOTE﹕ 12. Belt Clip (Please see illustration below) This can be rotated thru 360 degrees to adjust the receiver to the desired angle. To detach the clip, simply rotate the clip 30 degrees to the right (clockwise) and use a Philips (-) screwdriver to remove. 5. Important Notes: 1. To avoid interference, monitoring systems and wireless microphone systems should not operate simultaneously using the same frequency band. 2.
NOTE﹕ 10 NOTE﹕ 11