Bluetooth Speaker FCC ID:R2MHI-BOMB
Volume up + / Button Multifunction button Volume down - / Button Multifuntion LED Michrophone Jack 3,5mm Micro USB plug Users manual
Switch on hi-Bomb Bluetooth®. To switch on hi-Bomb Bluetooth® hold the button until transparent fins turns on and hi-Bomb Bluetooth® emits 4 acustic tones. Afterwards hi-Bomb automatically connects itself to the last paired device, if available, and the warning LED flash slowly in blue to confirm the connection. If there is no available paired device or if it is out of range, hi-Bomb Bluetooth® turns off in about 7 minutes in order to prevent battery from discharging. Pair hi-Bomb device.
to hi-Bomb Bluetooth®. Switch off hi-Bomb Bluetooth®. To switch off hi-Bomb Bluetooth® hold the power button untill the transparent fins flash red. *Only if paired to a mobile phone. Bluetooth® functions. Playing music. Thanks to the buttons of hi-Bomb Bluetooth® it is possible to play, stop and control music on your device connected via Bluetooth. Moreover it is possible to adjust the volume. To play:press shortly the button .
possible to make and receive calls, as using a Bluetooth headset, thanks to the internal microphone and to the buttons on the side. Answer a call: to answer a call press briefly the button . End a call: to end a call press briefly the button during the call. Reject an incoming call: To reject an incoming call hold the button for 2 second until you hear a long tone, then release the button the incoming call is rejected.
plug is connected the Bluetooth connection remains active but the priority is given to the jack input. When hi-Bomb Bluetooth® is used with the jack input, it is only possible to control the volume. All other functions must be controlled on the connected device. The power button act as MUTE button. Pressing it once will mute the volume (note: it does not stop the reproduction), pressing it once again will restore the previous volume setting.
Bomb Bluetooth® charger cable to a charger equipped with USB port, or alternatively, to an USB port on your laptop/ computer. It is possible to charge hi-Bomb Bluetooth® while it is in use. As soon as the charger cable is connected to the plug (8), the transparent fins(2) turn on red and they turn off once the charging is complete. When hi-Bomb Bluetooth® is fully charged it is possible to unplug it from the charger.
showers, saunas or swimming-pools. 'R QRW GURS GLVDVVHPEOH RSHQ RU KLW KL %RPE %OXHWRRWK with sharp objects. 'R QRW SODFH KL %RPE %OXHWRRWK QHDU PLFURZDYH RYHQV KHDW VRXUFHV 'R QRW SDLQW LW &OHDQ KL %RPE %OXHWRRWK ZLWK D GU\ WRZHO RQO\ 'R QRW H[SRVH KL %RPE %OXHWRRWK WR H[WUHPH KRW RU extreme cold environments. 'R QRW H[SRVH KL %RPE %OXHWRRWK WR GLUHFW VXQOLJKW IRU extended periods. 'R QRW H[SRVH KL %RPE %OXHWRRWK WR ILUHV OLNH ILUHSODFHV kitchen or candles.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
