Service manual

- 6 -
egasseMrorrE
DEL
edoC
rorreoN00
devreseR10
)noitcetorPtnerruCrevO(PCO20
noitcetorPegatloVrevO30
cnySlacitreVoN40
norewoptarorrERKI50
norewoptawolsenilatadro/dnakcolcsubCII60
norewoptaegdelwonkcasubCIIonMVN70
noitcetorPlatnoziroH80
norewoptaegdelwonkcaonrenuT90
rorrErossecorPdnuoS01
devreseR11
rorrEetarnacS21
rorrECAD31
rorrEdnekcaB41
rorrEecnegrevnoCcimanyD51
rorrEPIP61
AE-6BAD/Y SELF DIAGNOSTIC SOFTWARE
The identification of errors within the AE-6BAD/Y chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In
the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous
flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant
device number will be displayed through the LED (Series of flashes which must be counted) See table 1, non fatal errors are reported using this
method. Each time the software detects an error it is stored within the NVM. See Table 2.
Table 1
How to enter into Table 2
1. Turn on the main power switch of the TV set.
2. Program Remote Commander for Operation in Service
Mode. [See Page 21].
3. Press ‘AUX/VIDEO’ ‘AUX/VIDEO’ > ‘MENU’ on the
Remote Commander.
4. Using the Remote Commander, Scroll to the ‘Error’ item
using the down arrow key, then press the right arrow
key.
5. The following table will be displayed indicating the error
count.
Table 2
Note: To clear the error count data press ‘80’ on the Remote
commander.
Flash Timing Example : e.g. error number 3
StBy LED
ON ON ON
OFF
OFF
rotinomrorrE
)setuniM:sruoH(:EMITGNIKROW
33:28
:sretnuocrorrE
PCO:20E0
PVO:30E0
CNYSVON:40E0
RKI:50E0
CII:60E0
MVN:70E0
TORPH:80E0
RENUT:90E0
DNUOS:01E0
STLOV9:11E0
ETARNACS:21E0
BMOCD3:31E0
DNEKCAB:41E0
NOCNYD:51E0
EGATLOVHGIH:61E0
HCTIWSVA:71E0
CEDAMORHC:81E0
ACRF:91E0
GNEJP:02E0
CAD:12E0
TORPREKAEPS:42E0
KCITSYROMEM:52E0
:tceleS:uneMsuoiverP