Owner's manual

Matrix Switcher Series—User Manual

 IR EXT: This is used to connect the IR Receiver Cable for the Matrix Switcher Remote

Controller. Refer to 錯誤! 找不到參照來源。.

 INPUT1~16: Matrix Switcher Input jacks are connected to the Blu-ray players, DVD

players, STBs or other source devices.

 OUTPUT1~16: Matrix Switcher Output jacks are connected to the HDTVs, projectors

or other sink devices.

HDMI Type A Connector pin definition:

Pin # Signal Pin # Signal

1 TMDS Data2+ 11 TMDS Clock Shield

2 TMDS Data2 Shield 12 TMDS Clock-

3 TMDS Data2- 13 CEC (NC on device)

4 TMDS Data1+ 14 Utility (NC on device)

5 TMDS Data1 Shield 15 DDC-SCL

6 TMDS Data1- 16 DDC-SDA

7 TMDS Data0+ 17 DDC-Ground

8 TMDS Data0 Shield 18 +5V Power

9 TMDS Data0- 19 Hot Plug Detect

10 TMDS Clock+

 IR Tx1~16 Ports: Used to connect to the IR Blaster Cable for IR pass-through.

IR Blaster Pin Definitions:

 IR Rx1~16 Ports: Used to connect to the IR Receiver Cable for IR pass-through.

IR Receiver Pin Definitions:

P+

N-

GND

+5V

Signal