Manual

Matrix Switcher Series—User Manual
31
7.1.3 Connect Matrix Switcher and PC
You must power off the Matrix Switcher. Then, connect the Matrix RS-232 port to the PC
RS-232 port with the bundled communication cable. And make sure the DIPs on the rear
panel are set to Master and RS-232. (Refer to the previous section 6.6.1 RS-232)
7.2 Matrix Configuration
After finishing installation, click to active AV Matrix Application. In the
“Options” window, select the connected PC Port number and Baud rate, and then click
“OK”.
Figure 7-2 AV Matrix Options Window
The software controls signal connection between the corresponding input port and
output port as required. The AV Matrix software application main window is shown as
below:
Figure 7-3《AV Matrix》Software Application Main Window