Owner manual

M
M
M
R
R
R
M
M
M
-
-
-
6
6
6
0
0
0
2
2
2
P
P
P
24
C. DIP Switcher Pin 7: Switch between RS-232 port and LAN port connection. The
default value is “OFF”.
ON: RS-232
OFF: LAN
D. DIP Switcher Pin 8: Reset the web server IP address to 192.168.0.3, the default
value is “OFF”.
The steps are as below:
1. Please adjust the pin8 to ON and re-start the Switcher.
2. After the Switcher re-starts about 10 seconds, shut down your equipment.
3. For a normal operation, please adjust the pin8 to OFF, then power on the Switcher
again. The IP address will be restored to the default value: 192.168.0.3
6.5.5 Device ID Settings
Device ID Settings
The Device ID determines the position of a Matrix system. When multiple Matrix products
are connected to one PC or when the Matrix products are serially connected, the Device
ID decides which Matrix product is to be controlled. Device ID must not set to same
number. Use the ON/OFF switches 1, 2, 3, 4, 5 on the rear panel to set the ID number as
below:
Number Setting Table
ID Address
（Decimal）
ID Address
（Hexadecimal）
ID Address
（Binary）
ON/OFF Switching Positions
SW5 SW4 SW3 SW2 SW1
0 00 00000 ON ON ON ON ON
1 01 00001 ON ON ON ON OFF
2 02 00010 ON ON ON OFF ON
3 03 00011 ON ON ON OFF OFF
4 04 00100 ON ON OFF ON ON
5 05 00101 ON ON OFF ON OFF
6 06 00110 ON ON OFF OFF ON
7 07 00111 ON ON OFF OFF OFF
8 08 01000 ON OFF ON ON ON
9 09 01001 ON OFF ON ON OFF
10 0A 01010 ON OFF ON OFF ON
11 0B 01011 ON OFF ON OFF OFF
12 0C 01100 ON OFF OFF ON ON
13 0D 01101 ON OFF OFF ON OFF