Specifications

Installing the Driver Software
ISDN-Controller B1 PCI v4.0 – 6 Installation in Windows 2000 25
1. Start your computer.
The “Found New Hardware Wizard” recognizes a new
Plug & Play device to be installed.
2. First specify the D-channel protocol to be used. Select
the DSS1 (Euro ISDN) protocol here, even if 1ESS or
NI1 is used on your line. Confirm your selection by
clicking “Next”.
3. Enter the desired multiple subscriber numbers in the
“Phone Number and SPID Information” window.
The settings performed in this dialog are relevant only
for the NDIS WAN CAPI Driver (Internet, RAS over Dial-
Up Networking). They have no effect on other ISDN
software.
The MSNs entered here are valid for both incoming
and outgoing calls. The first MSN entry is valid for the
first B channel; the second for the second B channel. A
maximum of two B channels is supported by the ISDN
NDIS WAN CAPI Driver. When a B channel is busy, the
first MSN (default MSN) will be signaled as the outgo-
ing MSN. Tip: simply enter the same MSN for both
B channels to monitor all costs accrued on this num-
ber.
4. Click “Next”.
Please wait a few seconds. Installation of the ISDN-
Controller B1 PCI v4.0 will be concluded. The ISDN-
Controller is now ready for immediate operation.
Once the driver installation is concluded, the second step
is to update the driver software from the installation CD.
We recommend that you always install the current driver
software from the installation CD or the ADC to take advan-
tage of the entire potential of the ISDN-Controller
B1 PCI v4.0 (for instance, faxing on two B channels simulta-
neously).
1. Run the SETUP.EXE file.
This files is located in the CARDWARE\B1_PCI\
WINDOWS.2k\ENGLISH folder on the installation CD.