Operation Manual

Installing and Configuring KEN! Service
KEN! – 2 Installing and Configuring KEN! Service 17
2 Installing and Configuring
KEN! Service
This chapter first describes the installation of KEN! Service
and then explains how the KEN! Service PC must be config-
ured to work with KEN!.
All installation steps described refer to installation in Win-
dows Me unless otherwise specified. Minor variations may
be necessary for other Windows operating systems.
All steps of installation and configuration are accompanied
by function tests. These tests ensure at each step that the in-
dividual KEN! services and components are installed and
configured correctly.
The chapter concludes with a section explaining how to unin-
stall KEN! Service.
2.1 Installing KEN! Service
Proceed as follows to install KEN! Service:
Step 1:
Test the ISDN Adapter
Before installing KEN! Service, check that your ISDN adapter
is functioning properly. Proceed as follows:
1. Start the FRITZ!data program using the menu com-
mands “Start / Programs / FRITZ!”.
2. If the ISDN adapter in your KEN! Service PC is connected
to a PBX, check the “PBX” dialog page in “File / Set-
tings” to determine whether it is configured for outside
line access.
3. Then click the “Dial” button in the tool bar. A window
appears in which information may be entered for re-
mote connections.