Operation Manual

Step 2: Check the Network Adapter
22 KEN! – 2 Installing and Configuring KEN! Service
6. If you made any changes to these settings, apply them
and save your entries. Keep your Windows CD ready
and restart Windows.
Windows NT
For a KEN! Service installation on a Windows NT 4.0 comput-
er, it is imperative that the current Microsoft Service Pack be
installed on this computer first. Moreover, the Service Pack
must be reinstalled after every change which required in-
serting the Windows NT CD. This is the only way to ensure
that the current Service Pack files are always installed on
your computer.
1. Click through “Start / Settings / Control Panel / Net-
work” to open the Windows network settings.
2. Select the “TCP/IP Protocol” entry on the “Protocols”
settings page.
The TCP/IP protocol in Windows NT. These settings may look
different on your computer.
3. If the entry is not listed, add the binding by clicking
“Add... / Protocol / Microsoft / TCP/IP Protocol”.
4. Click “Properties...” and specify an IP address for the
network adapter.
In the entire KEN! manual the IP address 192.168.115.1
is used as the specified IP address. We recommend as-
signing this IP address for the KEN! Service PC as long
as there is no conflict with existing settings.