Operation Manual

Installing and Configuring KEN! Client
KEN! – 3 Installing and Configuring KEN! Client 43
3 Installing and
Configuring
KEN! Client
This chapter first describes the installation of KEN! Client,
and then explains which settings must be made on the KEN!
Client to work with KEN!.
All installation steps described refer to installation in Win-
dows Me unless otherwise specified. Minor variations may
be necessary for other Windows operating systems.
All steps of installation and configuration are accompanied
by function tests. These tests ensure at each step that the in-
dividual KEN! services and components are installed and
configured correctly.
The chapter concludes with a section explaining how to re-
move KEN! Client.
3.1 Installing KEN! Client
Proceed as follows to install KEN! Client:
Step 1:
Check the Network Adapter
Determine whether the TCP/IP protocol is bound to the net-
work adapter on the KEN! Client and how the IP address is
assigned. Proceed as follows:
Windows Me, 98 and 95
1. Click through “Start / Settings / Control Panel / Net-
work” to open the Windows network settings.
2. Look for the “TCP/IP” entry in the list of installed net-
work components. If the TCP/IP protocol is not available
on the computer, add the protocol using the commands
“Add... / Protocol / Microsoft / TCP/IP”.