Operation Manual

Step 1: Check the Network Adapter
46 KEN! – 3 Installing and Configuring KEN! Client
Windows 2000
1. Click through “Start / Settings / Control Panel / Network
and Dial-up Networking” to open the Windows network
settings.
2. Select the “LAN connection” entry, open the context
menu and select “Properties”.
3. Look for the “Internet Protocol (TCP/IP)” entry in the list
of installed network components and click “Proper-
ties”.
TCP/IP protocol binding to a network adapter in Windows
2000. These settings may look different on your computer.
We recommend obtaining an automatically assigned IP
address from the KEN! Service PC. Click “OK” to select
this option. This concludes the configuration test. Con-
tinue reading from „Step 2: Start KEN! Client Installa-
tion“ auf Seite 49.
4. It is also possible to assign KEN! Clients static IP ad-
dresses. In this case, check the following settings:
– These IP addresses may not conflict with the set-
tings on the KEN! Service PC (see „Step 2: Check the
Network Adapter“ auf Seite 19; the IP address
192.168.115.1 was named as an example there. The
example allows the static IP addresses
192.168.115.2 through 192.168.115.254).