Operation Manual

English
139
Appendix C: Support for Multiple Subscriber Numbers
msn -f<x>
msn -r<x>
EAZ=0, it will respond to all MSNs configured in the
system by MSN.EXE.
2. Load the ISDN-Controller.
3. Run MSN.EXE to assign an MSN to the EAZ configured
in Step 1. Use the following syntax:
msn -s<x>=<yyyyyyy>
where <x> is the EAZ and <yyyyyyy> is the desired
MSN.
Example: To map the subscriber number 1234567
to EAZ 5, type at the DOS prompt:
msn –s5=1234567
When this is done you may begin working with the
application.
The assignment of a given EAZ to an MSN can be
canceled either by running MSN.EXE again with the
parameter “–f” (see below), or by removing the CAPI
driver from memory.
Displaying MSN Mapping
Use the following parameters to display the currently
active EAZ assignments:
Display all EAZ assignments
Display the MSN that is mapped to EAZ <x>
Canceling MSN Mapping
The following commands can be used to cancel MSN-EAZ
mapping:
Suspends the current MSN assignment for the EAZ <x>
so that it can be reassigned.
Resets the MSN assignment for the EAZ <x> so that the
CAPI driver is in its original state.
msn -d
msn -d<x>