Operating instructions

9
If you are using banana plugs secure the outer parts of the sockets (by clockwise turning) before
inserting the pin. This will prevent rattling. On delivery you may find that plastic plugs cover the 4mm
holes of the loudspeaker clips. These can be removed with a thin screwdriver.
To be able to fully appreciate the tonal qualities of the stereo amp you should keep the speaker cables
as short as possible. In this way extremely short paths between the power amplifier and the
loudspeaker, for the transport of electrical power, is achieved. We recommend that you use cables of
identical length for right and left channel. This gives the best tonal balance.
There are loudspeakers that react through a short cable with tense, although weak, bass tones. This
results from long cables being used during the development of these loudspeakers. You might say the
cable is a component of the frequency-dividing network and therefore responsible for the tone. This
type of loudspeaker is best operated through long cables. In case of doubt ask your dealer.
2.6 DISPLAY mode
If you the display disturbs you while listening to music, you can switch it off by pressing the DISPLAY
button (4).