Aeronautical Navigator COCKPIT DOCKING STATION INSTALLATION GUIDE Standard and OEM Versions Your Journey, Our Technology
Aeronautical Products EKP V Docking Station DISCLAIMER & WARNINGS This product is not TSO-certified and have received no EASA or FAA approval. This product is not intended for installation in type-certificated aircraft. Avoid installing the product near heat sources or ensure adequate cooling is provided. Avoid routing of the wiring near sources of heat, RF or EMI interference. The included USB GPS antenna is not suitable for external use.
Aeronautical Products EKP V Docking Station General Description The EKP V Cockpit Docking Station (CDS) allows the installation of AvMap EKP V Aeronautical Navigator into the cockpit, and enables the unit to interface to multiple external devices at the same time. When docked the EKP V is powered/charged by the aircraft electrical system.
Aeronautical Products EKP V Docking Station Dimensions and Specifications Versions: • Standard (UX0DS100AM) : including the wire clamp board adapter. • OEM (UX0DS200AM): including a DB15 adapter for direct wire soldering Interfaces: • 4 x USB 2.0 ports (1 x battery powered by EKP V internal), • 2x Serials ports (1 x RS-232, 1 x TTL levels), • Audio IN, • Audio OUT, • Video IN (video composite signal PAL or NTSC), • Push-To-Talk • Power input voltage: 10-35 VDC (28 W max.), • Temperature range -20, + 70 °C.
Aeronautical Products EKP V Docking Station Back Side D Battery powered USB Port: backup power provided by the EKP V internal battery. E Normal USB Ports: powered by the aircraft electrical system. F DB 15 direct soldering connector (OEM version only). G Wire clamp connector (Standard version only). H Cable locking bar.
Aeronautical Products EKP V Docking Station Wiring and connections USB Ports The CDS includes four USB ports to connect AvMap's or approved third-party modules to the EKP V. One of the ports (D) is powered by the EKP V internal battery to ensure functionality even in case of aircraft electrical power failure. Battery powered USB Port: backup power provided by the EKP V internal battery.
Aeronautical Products EKP V Docking Station OEM Version DB-15 Connections DB-15 electrical pin-out 1 9 15 8 DB-15 Connections External Power Supply Input (10-35Vdc) 1 GND - EXT 9 EXT+ Video Input 11 VID-IN 3 AUDIO-VIDEO GND Audio Input 5 AUDIO VIDEO GND Pin # Signal 1 GND - EXT 2 GND 3 AUDIO-VIDEO GND 4 AUDIO IN 5 AUDIO VIDEO GND 6 RXA 7 GND 8 TXB 9 EXT+ 10 PUSH TO TALK 11 VID-IN 12 AUDIO OUT 13 GND 14 TXA 15 RXB 8 - Installation Guide 4 AUDIO IN Audio Output 12 AUDIO OUT 5 AUDIO VIDEO GND Serial In
Aeronautical Products EKP V Docking Station CDS Installation 1. 2. 3. 4. 5. 6. OEM Version Standard Version Cut the cockpit using the cutting template provided in the box. Connect and secure the included DB-15 interface (direct soldering or clamp board, depending on the CDS version) on the back of the CDS. Connect required wires to DB-15 connection, as explained in the previous chapter. Connect USB cables and secure them with the included safety lock bar.
Aeronautical Products EKP V Docking Station Docking the EKP V A1 A2 1 2 3 NOTE: when the EKP V is not docked the CDS can be protected by installing its plastic protective cover.
www.avmap.it www.avmap.