Switch User Manual

54 AutoView 3050/3100/3200 Switch Installer/User Guide
Figure 4.7: Active Directory - Define Groups
Setting up Active Directory for Performing Queries
Before you can use any of the querying modes for units, you must first make changes to Active
Directory so that the selected querying mode can assign the applicable authorization level for the
user.
To set up group queries:
1. Log into Windows with administrator privileges.
2. Open Active Directory software.
3. Create an organizational unit to be used as a group container.
4. Create an object in Active Directory with a name iden
tical to the switching system name for
querying appliances (specified in the Appliance Overview screen of the OBWI), or identical to
the attached target devices for querying target devices. The name must match exactly,
including case.
5. The appliance names and target device names used for group queries are stored in the
ap
pliance. T
he appliance name specified in the Appliance Overview screen of the OBWI and
target device names must identically match the object names in Active Directory. Each
appliance name and target device name may be comprised of any combination of upper-case
and lower-case letters (a-z, A-Z), digits (0-9) and hyphens (-). You cannot use spaces and
periods (.) or create a name that consists entirely of digits. These are Active Directory
constraints.