Cyclades-PR2000 Access Router Installation Manual

110Chapter 12 - Filters and Rules
Cyclades-PR2000
The configured rules will appear as shown in the following listing.
Rules Lists
Rule List
Name
Rule Default List Linked
Status Scope Type Rule
List
web_access Enabled Traffic
Filter_list Name web_access
Rule 0 Rule 1
Status Enabled Status Enabled
Flow priority 1 Flow Priority 2
Rule bandwidth 0% Rule bandwidth 0%
Bandwidth priority 0 Bandwidth priority 0
Protocol TCP Protocol TCP
Source IP Operator None Source IP Operator None
Destination IP
Operator
None Destination IP
Operator
None
Source Port Operator Equal Source Port Operator None
Source Port Start 80 Destination Port
Operator
Equal
Destination Port
Operator
None Destination Port
Start
SMTP
FIGURE 12.10 OUTPUT SHOWING PARAMETERS FOR TRAFFIC RULE EXAMPLE 2
Note that for this type of traffic control, of the traffic-specific parameters only Flow Priority is used. The
Reserved Bandwidth and Bandwidth Priority parameters are not important. A system needing all three is
conceivable, but much too complicated to show in this manual.