AutoView Switch User's Manual Model 1400, 1500 and 2000

34 AutoView 1400/1500/2000 Installer/User Guide
NOTE: AVRIQ or IAC modules may appear to be offline while being upgraded.
Figure 3.18: Diagnostics Dialog Box
Next to each item to be tested, you will see a pass (green circle) or fail (red x) symbol display to
the left of each item as that test finishes. The following table details each of the tests.
To run diagnostic tests:
1. If the OSCAR interface is not open, press
Print Screen. The Main dialog box will appear.
2. Click Commands
- Run Diagnostics. A warning message displays indicating that all users will
be disconnected.
Table 3.5: Diagnostic Test Details
Test Description
Memory Tests Reports on the condition of the main board RAM
Firmware CRCs
Reports on the condition of the main board RAM
Comm Interfaces Validates the current firmware images stored in the system’s Flash
Switch Controller test Verifies the switch matrix controller is accessible and functional
Local Video
Indicates the condition of the local video monitor
On-line Targets
Indicates the total number of currently connected and powered targets
Offline Targets
Indicates the number of targets that have been connected successfully in the
past and are powered down
Suspect Targets
Indicates the number of targets that have been detected, but are either
unavailable for connection or have dropped packets during the ping tests