User guide

14 AutoView Installer/User Guide
To cascade multiple AutoView units:
1. Follow steps 1-7 of the procedure To install an AutoView switch.
2. Plug the 25-pin D connector of your input cable into one of the available
channel ports on the rear of your primary AutoView unit.
3. Plug the 15-pin video connector on the other end of the cable into the
appropriately labeled port on your fi rst cascading AutoView unit. Plug the
PS/2 mouse and keyboard connectors into the appropriate ports.
4. Repeat steps 2-3 for every cascaded AutoView unit in your system.
5. Power up your AutoView unit(s) fi rst, then all attached computers.