User guide

116 DSView Installer/User Guide
3. In the Arrow Keys list, choose either VT100 or ANSI. The default value is VT100.
Changing the terminal type
The terminal type is used during Telnet session negotiation. You may change this value at any time.
To change the terminal type:
1. Select Options - Session Properties from the menu bar.
- or -
Click the Session Settings icon in the toolbar.
2. Click the Terminal tab.
3. In the Terminal Type box, enter a value of up to 40 characters, beginning with a letter and end-
ing with a letter or digit. Valid characters are the letters A-Z, digits 0-9, forward slash, dash,
left parenthesis and right parenthesis.
NOTE: When you are connected to a DS appliance, the terminal type must be entered in the Terminal Type field
exactly as shown in the following table for each Terminal Emulation mode.
Changing the linefeed settings
When connecting to devices that do not insert a carriage return in incoming or outgoing data, you
may instruct the DSView management software to automatically insert a line after each line of data.
This prevents overwriting data when a new line is received.
To change the linefeed settings:
1. Select Options - Session Properties from the menu bar.
- or -
Click the Session Settings icon in the toolbar.
2. Click the Terminal tab.
Table C.2: Terminal Emulation Mode and Type
Terminal Emulation Mode Terminal Type
VT52 DEC-VT52
VT100 DEC-VT100
VT100+ DEC-VT100
VT102 DEC-VT102
VT220 DEC-VT220
VT320 DEC-VT320