User guide

56 DSView Installer/User Guide
Rebooting and Changing Power States
If you have Administrator privileges, you may perform a warm reboot on a DS appliance at a
remote location.
To reboot a remote DS appliance:
1. Select the DS appliance in the DSView management software window.
2. Select Tools - Reboot.
- or -
Right-click and select Reboot from the shortcut menu.
- or -
Click the Reboot toolbar icon.
A confirmation dialog box will appear.
3. Click OK to reboot the remote DS appliance.
Changing the SPC device power state
NOTE: To change the power state of a target device powered by an SPC device, the SPC device must be
connected to a CPS810 appliance or CPS1610 appliance. For more information on connecting an SPC device to
a CPS appliance, see the SPC Installer/User Guide.
The power state of any device powered by an SPC device outlet may be turned on or off. The SPC
device outlet may also be used to reboot a server.
To change the SPC device power state:
1. Load the DSView management software. This will activate the Node Manager and display a
list of DS appliances with ports linked to SPC devices that you may access.
2. From the DSView management software window, select a port or channel associated with an
SPC device outlet or an unassociated SPC device outlet, then right-click on the item and select
Power State from the shortcut menu. This will open the Power State dialog box with the cur-
rent power state of the SPC device outlet selected.
The following items appear in the dialog box when the corresponding conditions occur:
• If the selected port or channel has an associated link to an SPC device outlet or if an unassoci-
ated SPC device outlet was selected, its current power state will appear in the dialog box.
• If there is an associated link for the selected port or channel, the name of the outlet(s) will
appear in the dialog box.
• If there is an associated server for a selected outlet, the name of the server will appear in the
dialog box.