User's Manual

Cyclades-PR1000

31Chapter 4 - Step-by-Step Instructions

CONFIG=>STATIC ROUTES=>IP=>ADD ROUTE

Parameter Example Your Application

Destination IP Address Type in the word "DEFAULT".

Gateway or Interface Gateway

Gateway IP address Use the same value as for

Destination IP Address in the

previous table.

Metric 1

Is This a Backup Route? No

OSPF Advertises This

Static Route

FIGURE 4.8 STATIC ROUTE MENU PARAMETERS FOR GATEWAY ROUTE

STEP SEVEN

NAT must now be activated. There are two varieties of NAT: Normal and Expanded. This example uses the

Normal NAT Mode. The other mode is explained in the chapter on NAT in the Installation Manual.

Menu CONFIG =>SECURITY =>NAT =>GENERAL

Parameter Example Your Application

Nat Status Enabled

Nat Mode Normal

Disable Port Translation No

FIGURE 4.9 NAT GENERAL PARAMETERS

STEP EIGHT

NAT parameters will now be determined for routing outside of the local LAN. Network Address Translation maps

the local IP addresses, registered in the local address range menu below, to the one global IP address assigned

by the access provider. Local IP addresses not indicated in this menu will be discarded.