User guide

14. Place the Receiver near the monitor and con-
nect your monitor, keyboard, mouse, speakers
and microphone to the connectors on the rear
of the Receiver just as you would connect them
to your PC. Make sure you connect your moni-
tor and your speakers’ power supply to appro-
priate electrical outlets. You must use speakers
with built-in amplifiers for proper operation.
15. If you connected the Transmitter for a serial
mouse, plug your serial mouse into the
connector on the rear of the Receiver. If you
are using a PS/2 mouse and you are extending
your computer’s serial COM port for some
other peripheral, plug this peripheral into the
Receiver’s
connector.
16. Connect the Category 5 cable to the remote
I/O jack on the rear of the Receiver. Verify that
the POWER light on the front of the Receiver
is lit. The Receiver gets its power from the
Transmitter through the Category 5 cable, so
no power supply is required at the Receiver.
(You may choose to connect the LongView
wall-mount power supply to the Receiver
rather than the Transmitter. If so, verify that
the Transmitter’s POWER light is now lit.)
17.For Companion models: The three position
slide switch on the front of the Transmitter is
a privacy switch to allow two users to share
the computer or for either user to be locked
out.
18. Turn on the computer and your monitor and
you are ready to go!
LongView Installer/User Guide
14