User guide
2. Specify the events that will generate notifications by clicking the appropriate checkboxes
in the list.
-or-
Select or clear the checkbox next to Event Name to select or deselect the entire list.
3. Click Save.
Setting Event Destinations
You can configure audit events to be sent to SNMPtrap destinations and Syslog servers. The
events enabled on the Events screen are sent to all the servers listed on the Event Destination
screen.
1. Select Unit View - Appliance - Appliance Settings - Auditing - Destinations to open the
Event Destinations screen.
2. Type the address of up to four management workstations to which this MergePoint Unity
switch will send events in the SNMP Trap Destination fields, as well as up to four Syslog
servers.
3. Click Save.
Configuring IQ Modules
From the Appliance IQ Modules screen, you can display a list of the attached IQ modules, as
well as the following information about each IQ module: EID, Port, Status, Application,
Interface Type and USB Speed. You can click on one of the IQmodules to view the following
additional information: Switch Type, Boot Version, Hardware Version, FPGA Version, Version
Available and Upgrade Status
You can also perform the following tasks: delete offline IQ modules, upgrade the IQ module
firmware, set the USB speed or decommission the IQ module.
To delete offline IQ modules:
1. From the side navigation bar, click Unit View - Appliance - Appliance Settings - Ports - IQ
Modules to open the Appliance IQ Modules screen.
2. Click Delete Offline.
To set the IQ module USB Speed (for DSAVIQ-USB2 modules only):
1. From the side navigation bar, click Unit View - Appliance - Appliance Settings - Ports - IQ
Modules to open the Appliance IQ Modules screen.
2. Select the checkbox(es) next to the IQ module(s) that you wish to modify.
Chapter 3: Local and Remote Configuration 35