User guide

• Ctrl-F9: While in Configuration mode, returns to the previous screen with History
mode enabled.
• Ctrl-F10: While in Configuration mode, returns to the previous screen with On-Line
mode enabled.
• Ctrl-F11: Clears the history buffer. If you choose this option, a warning screen will
appear. Press Enter to delete the history buffer or Escape to cancel the action. The
previous screen will reappear.
3. When finished, press Ctrl-F10 to exit History mode and return to On-Line mode.
DSRIQ-SRL module pinouts
Table B.1 lists the pinouts for the DSRIQ-SRL module.
DB9-F Pin
Host Signal Name Description Signal Flow SRL Signal Name Description
1 DCD - Data Carrier Detect Out of SRL DTR - Data Terminal Ready
2 RXD - Receive Data Out of SRL TXD - Transmit Data
3 TXD - Transmit Data In to SRL RXD - Receive Data
4 DTR - Data Terminal Ready In to SRL DSR - Data Set Ready
5 GND - Signal Ground N/A GND - Signal Ground
6 DSR - Data Set Ready Out of SRL DTR - Data Terminal Ready
7 RTS - Request to Send In to SRL CTS - Clear to Send
8 CTS - Clear to Send Out of SRL RTS - Request to Send
9 N/C - Not Connected N/A N/C - Not Connected
Table B.1: DSRIQ-SRL Module Pinouts
Using MPUIQ-SRL Modules
An administrator can choose between the ACS console server and Cisco® pinouts for each
MPUIQ-SRL serial port via the local user interface or the remote OBWI. ACS is the default.
To change the pinout to Cisco mode:
1. Select Unit View - Appliance - Appliance Settings - Ports - RIPs.
2. Click on the desired RIP.
3. Select Settings - Pinout.
Appendices 73