Switches Quick Installation Guide

Quick Installation Guide
Firewall Access
SwitchView IP
®
1020 Remote Access Device and DSR
®
Switches
The following instructions will help you
connect to the On-Board Web Interface
through a firewall.
For more detailed information, please consult
your installer/user guide.
To access the On-Board Web Interface through
a firewall
To Contact Avocent Technical Support CALL [phone] VISIT www.avocent.com/support DOWNLOAD www.avocent.com
Avocent, the Avocent logo, The Power of Being There, SwitchView and DSR are registered trademarks of Avocent Corporation. All other marks are the property of their respective owners. ©2006 Avocent Corporation. All rights reserved. 590-514-501A
1
2
The Power of Being There®
Introduction
You can configure your SwitchView IP 1020
remote access device or DSR switch to
allow users to connect to the On-Board Web
Interface through a firewall.
System configuration
In a typical configuration, the user’s server
is located outside of the firewall and the
SwitchView IP remote access device or DSR
switch resides inside the firewall. In this case,
the firewall must be configured to allow four
TCP/IP ports inside the firewall.
To configure the firewall
Configure your firewall to forward ports 80,
443, 8192 and 2068 from its external
interface to the KVM switch through the
firewall’s internal interface. Consult the
manual for your firewall for specific port
forwarding instructions.
To connect to the SwitchView IP or DSR
On-Board Web Interface
Open a web browser and enter the external IP
address of the firewall. The SwitchView IP 1020
Explorer or DSR Explorer will open and prompt you
to log in.
3
NOTE: For more information about the
SwitchView IP 1020 remote access device, see
the SwitchView IP 1020 Installer/User guide. For
more information about the DSR switch, see the
DSR Installer/User guide.
The firewall forwards HTTP
requests and KVM traffic to the
SwitchView IP remote access
device (shown) or DSR switch.
1
2
3
3
1
Firewall
The user browses to
the firewall’s external
IP address.
User’s
Server
SwitchView IP 1020
Remote Access Device
(shown) or DSR Switch