User Manual
Table Of Contents
- Introduction
- Features
- In The Box
- Specifications
- The Transmitter
- Indicator Troubleshooting Lights - Transmitter
- Functions & Setup of the Transmitter
- Settings Button - Transmitter without Dip Switches
- Test Pattern Button - Transmitter with Dip Switches
- The Receiver
- Indicator Troubleshooting Lights - Receiver
- Settings Button - Receiver
- IR Configuration
- Extracted Audio - L/R OUT
- Audio Extraction Example
- RS-232 Pass-through
- Troubleshooting
- Bandwidth Chart
- Maintenance
- Damage Requiring Service
- Support
- Warranty
15
Troubleshooting
·Verify Power - Check that the power supply is properly connected and on an active circuit. The
RX not receiving power (when powering from TX through the Category cable), bring the RX to
the TX and try a dierent Category cable to verify functionality.
·Verify Connections - Check that all cables are properly connected.
·TX/RX Indicator Troubleshooting Lights - Pg. 5-6
·IR Issues - Verify correct connections - P. 11-12
Note: Visibly ashing Emitters may not function properly, if you are experiencing issue try the
IR Cables that come in the box.
·Lights indicate everything is good but still not getting a picture, this may be a bandwidth
limitation. See Bandwidth Chart below to verify the signal is not exceeding the bandwidth of
the Extender kit (limited to 17.82Gbps).
Bandwidth Chart