User Manual
Table Of Contents
- Introduction
- Features
- In The Box
- Specifications
- The Transmitter
- Indicator Troubleshooting Lights - Transmitter
- Functions & Setup of the Transmitter
- Settings Button - Transmitter without Dip Switches
- Test Pattern Button - Transmitter with Dip Switches
- The Receiver
- Indicator Troubleshooting Lights - Receiver
- Settings Button - Receiver
- IR Configuration
- Extracted Audio - L/R OUT
- Audio Extraction Example
- RS-232 Pass-through
- Troubleshooting
- Bandwidth Chart
- Maintenance
- Damage Requiring Service
- Support
- Warranty
6
LINK - Above RJ45 (HDBT) Port: (Green) This indicator shows that the AV HDBT
link between the TX and Rx is in tact. This light should ALWAYS be solid. If this light is
ashing or not present attempt following:
1. Check the length. The maximum distances are 40m (131ft) on 4K and 70m (230ft) on 1080P.
2. Remove any coils of cable and make sure that there is not excess cabling.
3. Bypass all patch panels and punch-down blocks.
4. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is valid, something
may be slightly o.
a. Standard RJ45 ends are recommended. Pass through style types can cause interference/
crosstalk.
5. Contact AVProEdge if these suggestions do not work.
STATUS- Above RJ45 (HDBT) Port: (Amber) This is an indicator showing that the
power is present between the Transmitter and Receiver. This light ALWAYS BLINKS
steadily indicating everything is OK. If you do not see this light, attempt the following:
1. Check the length. The maximum distances are 40m (131ft) on 4K and 70m (230ft) on 1080P.
2. Remove any coils of cable and make sure that there is not excess cabling.
3. Bypass all patch panels and punch-dovwn blocks.
4. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is valid, something
may be just slightly o.
a. Standard RJ45 ends are recommended. Pass through style types can cause interference/
crosstalk
5. Try powering from the Receiver instead of the Transmitter (See Receiver page for more about
PoE direction).
6. Contact AVProEdge if these steps do not work. Contact AVProEdge if these suggestions do not
work.
Functions & Setup of the Transmitter
IR Mode Slide Switch: (On Back) This is used to select a preferred IR Mode for the
IR IN port. The two options are:
·IR-EYE - The IR Input will be congured to operate with an IR Receiver Eye.
·I-PASS - The IR Input will be congured to safely operate with a direct connection from a control
system using a mono or stereo 3.5mm cable. This is protected from 3v-20v. Default mode is IR-
EYE.
minimum is recommended per HDMI Specications.
3. Set the EDID to state #1 (See Page[s] 7).
4. If these suggestions do not work, enable the “Test Pattern” (See Page[s] 8). If you see the
pattern, the problem is between the source and the Transmitter, please try a dierent source.
5. Contact AVProEdge if these suggestions do not work.