User Manual
Table Of Contents
- Introduction
- Features
- In The Box
- Specifications
- The Transmitter
- Indicator Troubleshooting Lights - Transmitter
- Functions & Setup of the Transmitter
- Settings Button - Transmitter without Dip Switches
- Test Pattern Button - Transmitter with Dip Switches
- The Receiver
- Indicator Troubleshooting Lights - Receiver
- Settings Button - Receiver
- IR Configuration
- Extracted Audio - L/R OUT
- Audio Extraction Example
- RS-232 Pass-through
- Troubleshooting
- Bandwidth Chart
- Maintenance
- Damage Requiring Service
- Support
- Warranty
9
The Receiver
Indicator Troubleshooting Lights - Receiver
POWER - On the back by power supply input: (Red) This is an indicator that the
power is connected. There are only two states for light:
·Light Is On = Power supply is connected and functioning.
Light Is O = Power supply is not connected or there is no power present. In order to have power:
check the power supply, POE Switch on Reviver, USP, Outlet, etc...
HDBaseT
RS-232
POE
Mode
Micro USB
(Firmware)
L/R Out
(PCM Only)
IR OUT IR IN
HDMI OUT
Test Pattern
Enable/Disable
Power
Test Pattern Button - Transmitter with Dip
Switches
Use this button to Enable/Disable the built in 1080P Color Bar Test pattern.
Press once to Enable, press again to Disable.
NOTE: The Reciever also has built in test pattern generator� See page 10 for more details�