User Manual
Table Of Contents
- Introduction
- Features
- In The Box
- Specifications
- Troubleshooting Lights - Transmitter/Receiver
- Troubleshooting Lights (HDBaseT Port)
- Transmitter Ports
- Receiver Ports
- IR Configuration
- Audio
- EDID Management - Transmitter
- EDID Copy Instructions
- RS-232 Configuration
- Troubleshooting
- Bandwith Chart
- Maintenance
- Damage Requiring Service
- Support
- Warranty
13
RS-232 Configuration
For extending RS-232 communication over the Category
cable. For these to pass a signal, both the Transmitter
and Receiver need to have the Dip Switch set to Normal
Mode, not RS-232 Program.
Default out of the box is MODE NORM (Normal Mode).
RS232 PROG (Program mode for Firmware updating).